©

Short-term measures

Temporary measures for fast mould removal

If restoration cannot be commenced immediately, infested areas should be treated / disinfected temporarily without swirling any dust. It is important to observe all protective measures listed in the Bio-Substance Ordnance even for these temporary measures!

Cleaning without swirling of dust if possible

If restoration cannot be commenced immediately, infested areas should be treated / disinfected temporarily without swirling any dust. It is important to observe all protective measures listed in the Bio-Substance Ordnance even for these temporary measures!

Binding and affixing mould

Binding and affixing mould as a temporary measure, before actually undertaking mould restoration measures with the Remmers spore binder. The dust load and the mould concentration in the room air is reduced considerably. The spore binder is a special primer without solvents or plasticisers that binds mould spores and is also use to reduce mould-infested dust.

Properties:

  • Complexes and binds
  • Reduces the level of mould spores in the room air
  • Free of solvents and plasticisers
  • Can be thinned with water

laboratory employee ©
©

Cleaning & disinfection with Mould Stop

Cleaning & disinfection of areas infested with mould temporarily with a self-acting agent like Remmers Mould Stop, if possible without swirling dust.

This is an active special cleaning agent to remove biological deposits on tiles, joints, rendering, stone, plastic, painted surfaces and other water-resistant subsurfaces.

Properties:

  • Works independently
  • Fast
  • Solvent-free

Targeted venting & heating to reduce the growth of mould

Targeted venting & heating of mould-infested areas can reduce moisture and limit the further growth of mould.