• 0000026301_Power_Protect_P_40
    eco
    Product

    Article No. 0262

    Power Protect P 25 / P 40 [eco]

    Insulating board for environmentally sustainable mould control

    Button Der Blaue Engel schützt Umwelt und Gesundheit UZ 12a

    Product specifications

    On delivery

    Aw value / water absorption coefficient 41.82 kg/(m²h0.5)
    Reaction to fire B-s1, d0
    Porosity ≤ 94 vol.%
    Bulk density approx. 152 kg/m²
    w80 0.0047 m³/m³
    Water vapour diffusion approx. 6
    Water vapour diffusion resistance µ 6.1
    wsat 0.9427 m³/m³
    Thermal conductivity λ 0.05 W/(m∙k)

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors
    • Mould control and prevention in existing buildings
    • Implementation of the hygienic minimum heat insulation level in existing buildings
    • Improving the room climate by increasing the wall surface temperature

    Properties

    • Protects health and the environment, awarded the German Blue Angel and the eco label
    • Water vapour permeable
    • Capillary-active
    • Thermally insulating, lambda 0.05 W/(m•K)
    • Mould-inhibiting
    • Euroclass B-s1, d0
    • Low construction height
    • Easy to work
    • Preparation
      • Substrate requirements

        The substrate must be clean and capable of bearing a load.

        The substrate must be level.

      • Preparations

        Level off and even out highly uneven substrates – use SP Levell to seal joints and even out surfaces.

    • Application
      • Application temperature: min. 5 °C max. 30 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

      • VA1_M_705

        Apply the material vertically to the substrate with a middle-bed trowel (toothed).

        Press on the board, beginning at the bottom.

        A full-surface bonding is to be achieved.

    • Application instructions
      • Mark the desired dimensions on the board.

        Cut with a cutter knife or keyhole saw.

        Rework the cut edges with a rasp or file if necessary.

        Place the boards, starting at the bottom.

        Avoid cross joints.

        Make sure that the board surface is aligned correctly (the label "front side" must be visible after application).

        Then, use PP Fill to smooth off and create fine, closed surfaces that are ready for painting.

    • Storage / shelf life
      • Store frost-free
      • Unlimited if stored in frost-free conditions.

    • Usage
      • 1.4 panels / m²
      • Approx. 1.4 boards /m²

    • General information
      • Typical inherent odour after installation, while the finishing plaster is drying.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • The product must be disposed of in accordance with the official regulations.