Article No. 656210
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Dry, clean, free of dust and cracks (except hairline cracks) and capable of supporting a load.
Free of salts known to be damaging to building materials.
Pre-wet the substrate.
Using a suitable tool, apply the product as a contact layer.
Wait at least 12 hours between coats.
Smooth the surface using a suitable tool.
Finish the surface once set.
Can be sanded once set.
When coating continuous surfaces, only use materials with the same batch number.
Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.
Clean tools, equipment and any splashed material immediately with water while still fresh.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Always set up a trial area/trial areas first.
The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.
Low temperatures, poor ventilation and high humidity delay drying.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.