Article No. 745083
Two-component primer for joint sealants in permanently wet areas
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Joint sides must be clean, dry, free from grease and capable of bearing a load.
Temperature of the material, surroundings and substrate: from min. +5 °C to max. +40 °C
Using a suitable mixer, mix the material intensively for approx. 3-5 minutes until homogeneous.
Apply the material using a suitable tool.
Apply the next material within the specified reaction time (Δ min/max).
Low temperatures increase the setting time, while high temperatures decrease it.
Do not use on PMMA (e.g. Plexiglas).
When working on plastics, test first on an inconspicuous place.
Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.
Suitable stirrer, brush
Clean tools immediately after use with V 101 Thinner.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months.
According to needs
Apply to a large enough trial area to determine the precise amount required.
The applicable regulations and legal requirements must be observed.
The relevant test certificates must be observed when planning and carrying out work.
Always set up a trial area/trial areas first.
Use only outdoors or in a well-ventilated area.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.