Article No. 066601

    Clean FP

    Cleaning paste for removing urban dirt

    Product specifications

    On delivery

    Appearance Yellowish
    pH value (20 °C) Approx. 5.0
    Viscosity Approx. 1800 mPa∙s
    Carrier material Water

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use outdoors
    • Mineral building materials, apart from sand-lime brick and glazed surfaces
    • Removes heavy urban soiling (soot, dust, industrial dirt, etc.)

    Properties

    • Water-based
    • High cleaning power
    • Paste form
    • Does not run on vertical surfaces
    • Efficient application
    • Preparation
      • Preparations

        Mechanically remove coarse soiling.

    • Application
      • Scrubber
      • By brush/By roller/ Scrub brush/ High pressure cleaner
      • Application temperature: min. 5 °C max. 30 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

      • Apply the material using suitable equipment.

        Use a scrubbing brush to work the material again.

        Exposure time 2-5 min.

        Do not allow the material to dry.

        Rinse off thoroughly from bottom to top, using plenty of water under pressure.

        Remove cleaning agent until no residues remain.

        If needed, repeat the application.

    • Application instructions
      • Do not pre-wet!

        Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

        Set up the necessary collection receptacles.

    • Working tools / cleaning
      • Scrubber
      • By brush/By roller/ Scrub brush/ High pressure cleaner
      • Scrubbing brush, surface brush, ceiling brush, lamb's wool roller, high-pressure cleaner

      • Clean tools with water immediately after use.

    • Storage / shelf life
      • Shelf-life 36 months
      • Store frost-free and cool / protect for moisture / close containers
      • At least 36 months in unopened, original containers stored cool, dry and protected from frost.

    • Usage
      • Total application/absorption rate 0.1 - 0.3 kg Total / m²
      • Min. 0.1 kg/m² depending on the degree of soiling

      • Apply to a large enough trial area to determine the precise amount required.

    • General information
      • Cleaner residues may cause irreversible discolouration.

        The applicable regulations and legal requirements must be observed.

        The relevant test certificates must be observed when planning and carrying out work.

        Always set up a trial area/trial areas first.

    • Disposal instructions
      • Active ingredient residues and rinsing water that contains the active ingredients of the product must not be allowed to enter the surface water drainage system. Collect rinsing water and dispose of at a collection point or through the sewage system according to local regulations. For more information, see advisory leaflet DWA-M 370 on “Waste and sewage from the cleaning of and coating removal from facades”.

        The object must be reported to the relevant authorities.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Possible system products