Article No. 051325
Bedding cement for mould control panelling
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Bonding and reinforcement mortar, especially for use in the Remmers SLP system
- Mineral wall materials and substrates that are suitable for plastering
Properties
- Slows down capillary action
- Free of mineral fibres
- Long open time
- Reliable fixing and prevention against slipping
- Waterproof
-
Preparation
-
Substrate requirements
Clean, dust-free and capable of supporting a load.
-
Preparations
Pre-wet the substrate so that it is slightly moist.
Pretreat highly absorbent substrates with Primer Hydro F.
Level off and even out highly uneven substrates – use SP Level to close up joints and even out surfaces.
-
-
Application
-
Use the material to level out any unevenness of < 8 mm in the substrate.
A scratch coat is recommended as a preparatory working step.
Apply the material vertically to the substrate with a toothed smoothing trowel.
Press on the board, beginning at the bottom.
A full-surface bonding is to be achieved.
-
Application instructions
-
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Wait a minimum of 24 hours between bonding and filling panels.
-
-
Working tools / cleaning
-
Mixer, smoothing trowel, toothed trowel, trowel
-
Clean tools with water while the material is still fresh.
-
Storage / shelf life
-
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
-
Usage
-
Approx. 1.2 kg/m²/mm layer thickness, approx. 6-7 kg/m² including levelling
-
General information
-
Do not use on gypsum-based substrates.
The mixing water must be of drinking water quality.
May contain traces of pyrite (iron sulphide).
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Low chromate content in accordance with Directive 2003/53/EC.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-