Article No. 040825
Mineral fine render
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Clean, dust-free and capable of supporting a load.
Pre-wet the substrate so that it is slightly moist.
Pre-wet hydrophobic substrates with low surface tension water.
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
Using a suitable tool, apply the product as a contact layer.
Apply product in the desired coating thickness.
Smooth the surface using a suitable tool.
Finish the surface once set.
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Protect wet mortar surfaces against frost, rain and drying out too quickly for at least 4 days.
Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.
Apply additional diagonal reinforcement to the edges of building openings.
Do not interrupt work when coating continuous surfaces.
On larger surfaces and when there are several levels of scaffolding, coating should be carried out on all levels at the same time to avoid seams.
When coating continuous surfaces, only use materials with the same batch number.
Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.
Mixer, trowel, smoothing trowel, sponge float, felt float
Clean tools with water while the material is still fresh.
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
Approx. 1.3 kg/m²/mm, on average approx. 3.5 kg/m²
Apply to a large enough trial area to determine the precise amount required.
May contain traces of pyrite (iron sulphide).
Low chromate content in accordance with Directive 2003/53/EC.
Do not use on gypsum-based substrates.
The mixing water must be of drinking water quality.
Always set up a trial area/trial areas first.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.