• Quartz Primer

    Article No. 281005

    Quartz Primer

    Bonding layer and coating for mineral substrates with low absorbency

    Variant
    2810 | Quartz Primer
    Packaging unit

    Product specifications

    On delivery

    Density (20°C) Approx. 1.40 g/ml
    Colour White
    pH value approx. 8.2
    Viscosity 750 cp

    Once fully cured

    Once fully cured

    Alkali resistance up to pH 14

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors and outdoors
    • Mineral substrates with low absorbency (in-situ concrete formed with plastic sheet lined formwork, solid slab floors made of building elements, precast concrete unit elements produced with steel formwork)
    • Bonding layer between "render-unfriendly" substrate and the render to be applied
    • AW_GR_224
    • AW_GR_225

    Properties

    • Water-based
    • Increases roughness/non-slip properties
    • Good adhesive power
    • White pigmented
    • Coarse filler
    • Alkali-resistant
    • Preparation
      • Substrate requirements

        Dry, clean, free of dust and cracks (except hairline cracks) and capable of supporting a load.

        Free of salts known to be damaging to building materials.

    • Application
      • By brush / By roller / Airless/airmix spraying
      • Application temperature: min. 5 °C max. 25 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +25 °C

      • Stir well.

        Apply evenly to the material using a brush, roller or spray.

    • Application instructions
      • Drying

        Structural defects such as cracks, cracked joints, defective connections and rising damp must be remedied first.

        PL_VA2_BGT_36

        As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

        Please contact Remmers Technical Service (phone +49 5432 83-153) before applying with machine processing.

    • Working tools / cleaning
      • By brush / By roller / Airless/airmix spraying
      • Sheepskin roller, brush

      • Clean tools immediately after use with water.

    • Storage / shelf life
      • Shelf-life 12 months
      • Store frost-free and cool / protect for moisture / close containers
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

    • Usage
      • Approx. 250 ml / m² per layer applied
      • Approx. 0.2 - 0.3 l/m² depending on the substrate

      • Apply to a large enough trial area to determine the precise amount required.

    • General information
      • The relevant test certificates must be observed when planning and carrying out work.

        The current technical regulations must be observed.

        Deviations from applicable regulations must be agreed separately.

        Always set up a trial area/trial areas first.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.