Article No. 237901
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.
Apply an even coat of the material with a brush.
No wet puddles, run marks or drips may remain on the surface of the wood.
Repeat process while the material is still wet if necessary.
Seal opened containers well and use contents as soon as possible.
Check colour, adhesion and compatibility with the substrate by setting up a trial area.
Ensure good ventilation.
Because of the low viscosity, other processing methods (injection) may be used. However, this must be decided on a case-by-case basis by the person carrying out the work.
Contact Remmers Technical Service if necessary.
Practice values at +20 °C and 65% relative humidity.
Low temperatures, poor ventilation and high humidity delay drying.
Clean tools immediately after use with V 101 Thinner.
The material can no longer be cleaned off once it has dried or hardened.
Ensure that any residue from cleaning is disposed of correctly.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.