Article No. 316101
Two-component, solvent-free wood strengthener on an epoxy resin base
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.
Remove decomposed wood and loose wood fibres with a steel brush.
If necessary, treat the wood components with IG-10 Impregnation Primer IT for preventive protection against wood-destroying insects and fungi.
Temperature of the material, air and substrate: from min. +10 °C to max. +25°C
Stir well and apply quickly using a brush.
Repeat process while the material is still wet if necessary.
Check colour, adhesion and compatibility with the substrate by setting up a trial area.
Ensure good ventilation.
Because of the low viscosity, other processing methods (injection) may be used. However, this must be decided on a case-by-case basis by the person carrying out the work.
Contact Remmers Technical Service if necessary.
Clean tools immediately after use with V 101 Thinner.
The material can no longer be cleaned off once it has dried or hardened.
Ensure that any residue from cleaning is disposed of correctly.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Approx. 250 - 500 g/m² depending on the substrate
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.