• IG Acryl 3K

    Article No. 687501

    IG Acryl 3K

    Acrylate gel

    Product specifications

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on floors/walls indoors and outdoors
    • Curtain injection
    • Construction substrate consolidation and waterproofing
    • Joint backing


    • Three components
    • Expands with water contact
    • Low viscosity
    • Solvent-free
    • Very flexible
    • Swelling capable
    • Freeze/thaw-resistant
    • Preparation
      • Preparations

        Remove loose render layers.

        Tamp joints and damaged masonry.

        Use a suitable packer.

    • Application
      • Application requirements

        Temperature of the material, air and substrate: min. +5 °C

      • Using suitable injection technology, inject the material from bottom to top.

        Remove packer, seal boreholes if necessary.

        For further information, please refer to our application instructions at www.remmers.com.

    • Application instructions
      • Check the surface and component properties before carrying out injection work.

        Adjust the injection pressure according to the properties of the building component.

        Inject again if necessary.

        As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

    • Working tools / cleaning
      • Three-component pump; Patent Disperser; Mixcan; suitable packer; impact drill

      • More detailed information can be found in the Remmers Tool Programme.

        Wash tools and any splashed material with water immediately and while wet.

        Take suitable protective and waste disposal measures when cleaning.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 12 months for plastic buckets
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

    • Usage
      • Curtain injection: approx. 20 - 60 kg/m² (equals approx. 10 - 30 kg gel concentrate)

        To determine the precise quantity required, conduct trial injections on representatively selected, sufficiently large test areas.

    • General information
      • Unless otherwise specified, all of the values and application rates given above have been determined under laboratory conditions (20 °C). Slight deviations from these values may arise if the product is worked with on site.

        Adding the salt component IG Acryl Comp. to mixture B reduces the reaction time.

        You can find more information on application, system configurations and maintenance of the listed products in the relevant Technical Data Sheets, the application instructions, and the Remmers system recommendations.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • Further information concerning safety during transport, storage and handling as well as on disposal and ecology can be found in the latest Safety Data Sheet.

    Possible system products