Article No. 102825
Machine-workable jointing mortar with high sulphate resistance for embedding spiral anchors
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Clean, dust-free and capable of supporting a load.
Joint depth min. 6 cm
Sanded joint sides can lead to lateral detachment.
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
Pre-wet the open, cleaned joint.
Inject the first layer of mortar into the joint such that it is free of voids and press the spiral anchor into the centre.
While the previous layer is still wet, apply the second layer of mortar such that it is free of voids. Apply the material up to a level of 2 cm below the final surface and work with a jointing iron.
Wait at least 24 hours before applying subsequent layers.
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Protect wet mortar surfaces against frost, rain and drying out too quickly for at least 4 days.
Mixer, pointing gun, jointing iron
Clean tools and equipment with water before the mortar sets.
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
Approx. 1.7 kg/l cavity
May contain traces of pyrite (iron sulphide).
Do not use on gypsum-based substrates.
The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.
Low chromate content in accordance with Directive 2003/53/EC.
The mixing water must be of drinking water quality.
Alkaline binders may cause a dissolution process on non-ferrous metals.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.