Article No. 656210

    CL Fill Q3 Historic

    High-quality, ready-to-use filler based on “dispersed white hydrated lime”

    Colour: CL Fill Q3 Historic | 6562
    Packaging unit

    Product specifications

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • Interior areas on loam, lime, lime cement and other mineral renders, as well as natural stone, concrete and other absorbent mineral substrates
    • Monument preservation and eco-friendly construction

    Properties

    • Capillary-active
    • Diffusion open sd < 0.03 m
    • Allergy friendly
    • Naturally antiseptic
    • Grain size approx. 0.5 mm
    • Low-stress
    • Good adhesive power
    • Can be feathered out to zero
    • Preparation
      • Substrate requirements

        Dry, clean, free of dust and cracks (except hairline cracks) and capable of supporting a load.

        Free of salts known to be damaging to building materials.

        Absorbent

      • Preparations

        Pre-wet the substrate.

        VA1_RM_30

         

        VA1_RM_28

        VA1_RM_29

    • Application
      • Using a suitable tool, apply the product as a contact layer.

        VA1_SpM_1

        Wait at least 12 hours between coats.

        Smooth the surface using a suitable tool.

        Finish the surface once set.

        Can be sanded once set.

        VA1_M_717

    • Application instructions
      • Check the absorbency of the substrate on a sufficiently large test area.

        To prevent a crust forming, work wet-on-wet in a single operation.

        When coating continuous surfaces, only use materials with the same batch number.

        VA2_FS_8

        Substrates with moisture penetrating from the rear can cause discolouration.

        Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

        VA1_FS_6

    • Working tools / cleaning
      • Clean tools, equipment and any splashed material immediately with water while still fresh.

    • Storage / shelf life
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

    • General information
      • Always set up a trial area/trial areas first.

        The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

        Low temperatures, poor ventilation and high humidity delay drying.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Possible system products