Article No. 073881
Additive for modifying the flowability of Silicone AFM
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Shake the container or stir its contents vigorously before use.
Mix the thickening additive AFM with the ready-mixed silicone AFM in the selected ratio using a spatula or stirrer until homogeneous.
Single-use pipettes (20 drops = 1 g) or disposable syringes can be used to measure out small quantities of additive.
At low temperatures, the thickening additive AFM is viscous to solid and can be brought into a readily workable, liquid form by heating.
The product reacts with moisture in the air.
Re-seal containers immediately after use.
Clean tools immediately after use with thinner and brush cleaner.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Store in well-sealed, original containers, out of the reach of children and in a dry, cool, well-ventilated room which is protected from direct sunlight and frost. No smoking is permitted in storage areas.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.