• 0021094401_IR_Epoxy_100
    • 0021094401_IR_Epoxy_100

    Article No. 094401

    IR Epoxy 100

    Rigid two-component EP resin

    Variant
    0944 | IR Epoxy 100
    Packaging unit

    Product specifications

    On delivery

    Component A

    Density (20°C) 1.13 g/cm³
    Viscosity (25 °C) 300 mPa s

    Component B

    Density (20°C) 0.87 g/cm³
    Viscosity (25 °C) 75 mPa s

    Mixture

    Density (20°C) 1.07 g/cm³
    Viscosity (25 °C) 100 mPa s

    Once fully cured

    Once fully cured

    Tensile strength 51 N/mm² *
    Adhesive pull strength 7.4 N/mm² *
    Shear strength 16.8 N/mm² *

    Characteristic data of the product

    * after 7 days at 23 °C

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • Grouting cracks in concrete
    • Frictional coupling and bonding
    • Bonding hollow concrete and screed

    Properties

    • Low viscosity
    • Especially good flank adhesion
    • High adhesive pull strength and inherent strength
    • Preparation
      • Substrate requirements

        The flanks of the crack must be dimensionally stable and free from loose parts, sintered layers, oils, grease and other separating substances.

      • Preparations

        Plug the path of the crack if necessary.

    • Preparation
      • Mixing ratio comp. A 100 : comp. B 28
      • Mixing time 3 min
      • Combination container

        Add the entire quantity of the hardener (component B) to the basic compound (component A).

        Mix thoroughly with a slow-speed electric mixer
        (approx. 300 - 400 rpm).

        Mix for at least 3 minutes.

        Insufficient mixing is indicated by streaks forming.

        Pour the mixture into a separate container and mix again thoroughly.

    • Application
      • Working time 1 h
      • Application temperature: min. 8 °C
      • Application requirements

        Temperature of the material, air and substrate: min. 8 °C

    • Application instructions
      • As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

        Significant increase in viscosity at low temperatures.

    • Working tools / cleaning
      • Suitable mixer

      • More detailed information can be found in the Remmers Tool Programme.

        Clean tools, equipment and splashed material immediately while fresh with V 101 Thinner.

        Take suitable protective and waste disposal measures when cleaning.

    • Storage / shelf life
      • Store frost-free
      • Shelf-life 12 months
      • If stored unopened in the original container and kept cool, dry and protected from frost, min. 12 months (component A)/min. 24 months (component B).

    • Usage
      • 1.1 kg / l void
      • 1.1 kg/l cavity

    • General information
      • Unless otherwise specified, all of the values and application rates given above have been determined under laboratory conditions (20 °C). Slight deviations from these values may arise if the product is worked with on site.

        The current technical regulations must be observed.

    • Disposal instructions
      • Dispose of contents/container in accordance with local/regional/national/international regulations.

    • Safety / regulations
      • Further information concerning safety during transport, storage and handling as well as on disposal and ecology can be found in the latest Safety Data Sheet.

    Possible system products