PUA Color WL OS pro

The substrate must be firm, dimensionally stable, capable of bearing loads and free of loose constituents, dust, oil, grease, rubber marks and other substances that could interfere with adhesion.

The substrate must be dry.

Substrates may be prepared with e.g. Remmers PUR Color ZS OS pro in the Remmers Deck OS 10 PUA pro system.

The specified processing times must be followed.

Add the entire quantity of the hardener (component B) to the base compound (component A).

Mix thoroughly with a slow-speed electric mixer
(approx. 300 - 400 rpm).

Mix for at least 3 minutes.

As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

Smoothing trowel, flat brush, coarse textured roller, suitable mixing equipment

More detailed information can be found in the Remmers Tool Programme.

Clean tools and remove any contamination immediately after use and while fresh using Thinner V 103.

Take suitable protective and waste disposal measures when cleaning.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

Approx. 2.0 - 2.5 kg/m²

Pour the material on the prepared surface and distribute using a suitable tool, e.g. a smoothing trowel or flat brush.

Then use a coarse textured roller to roll the surface.

approx. 2.0 - 2.5 kg/m²

Unless otherwise specified, all of the values and application rates given above have been determined under laboratory conditions (20 °C) using standard colours. Slight deviations from these values may arise if the product is worked with on site.

Protect the coating against direct contact with water for the first 24 hours after application to prevent blistering.

Due to the short reaction time, the coating operation must be well planned and prepared.

The additional material needed to attain the minimum layer thicknesses (wearing layer) and cover the surface texture must be calculated.

Abrasive mechanical loads leave traces of wear.

Observe the application information for the Remmers Deck OS systems.

Further notes on working, system construction and maintenance of the listed products can be found in the latest Technical Data Sheets and the Remmers system recommendations.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For professional users only!

Further information concerning safety during transport, storage and handling as well as on disposal and ecology can be found in the latest Safety Data Sheet.