• WP RH rapid
    • WP RH rapid

    Article No. 101015

    WP RH rapid

    Quick-setting plugging mortar

    Colour: grey | 1010
    Size / Quantity

    Brochures and Catalogues

    product.brochures.loading

    Product specifications

    Compressive strength (28 d) > 30 N/mm²
    Initial setting (20 °C) Approx. 30 seconds
    Final set (20 °C) Approx. 40 seconds
    pH value Approx. 12
    Bulk density Approx. 1.2 kg/dm³
    Water requirement Approx. 0.3 l/1 kg
    Approx. 1.2 - 1.7 l/5 kg

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on floors/walls/ceilings indoors and outdoors
    • Rapid repair of leaking areas, seepage areas and water inrushes
    • Plugging under Remmers mineral waterproofing slurries
    • Repair and waterproofing of concrete, masonry work, render and shafts

    Properties

    • Reacts within seconds (begins to set after approx. 30 seconds)
    • Water pressure tight
    • Low shrinkage
    • Resistant to frost
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

      • Preparations

        Chisel out leaking areas to a width and depth of at least 3 cm; widen towards the inside in a wedge shape.

    • Application
      • Application temperature: min. 5 °C max. 30 °C
      • Jointing iron / Filling knife
      • Apply mixed small quantities with a suitable tool or by hand (wear protective gloves) on the prepared substrate.

        Alternatively, apply as powder by hand (wear protective gloves) to flow and seepage points.

        The powder sets with the trickling water.

        Repeat the process several times as necessary until the flow point is sealed.

         

    • Application instructions
      • In low outdoor temperatures, use warm water and material that has been stored at room temperature.

        In areas with high amounts of leaking or flowing water, use drainage tubes.

    • Working tools / cleaning
      • Jointing iron / Filling knife
      • Filling knife, jointer

        Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Protect form moisture
      • Shelf-life 12 months
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

        Once containers have been opened, the contents should be used within one week.

    • Usage
      • Approx. 1.7 kg / l void
      • Approx. 1.7 kg/l void

    • General information
      • Do not use on gypsum-based substrates.

        The mixing water must be of drinking water quality.

        May contain traces of pyrite (iron sulphide).

        Low chromate content in accordance with Directive 2003/53/EC.

        The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

        Alkaline binders may cause a dissolution process on non-ferrous metals.

        Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Possible system products