• Pflasterfugenmörtel M

    Article No. 033025

    Paving Mortar M

    Mineral paving joint mortar

    Colour: Paving Mortar M | 0330
    Size / Quantity

    Brochures and Catalogues

    product.brochures.loading

    Product specifications

    On delivery

    Loading Foot traffic after 24 hours
    Light loads after 3 days
    Compressive strength (28 d) Approx. 25 N/mm²
    Maximum grain size 2 mm
    Water requirement Approx. 3.8 l/25 kg

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on floors indoors and outdoors
    • Pointing paved surfaces in interior and exterior areas

    Properties

    • Low-stress and crack-free setting
    • Good flank adhesion
    • Very smooth and easy to apply as a grout
    • Easy to clean
    • Fast curing
    • Resistant to water, weathering and freeze-thaw cycles
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

      • Preparations

        Thoroughly pre-wet the substrate.

    • Application
      • By brush
      • Application temperature: min. 5 °C max. 30 °C
      • Spread the pourable mixture directly on the surface being covered.

        Carefully push into the joints using a rubber scraper and remove excess mortar.

        Keep the surface moist without flushing out the joints.

        Clean the surface with water and promptly remove any excess mortar in cavities and recessed areas, in particular on very rough coverings, using a short-bristled broom, rubber scraper and soft water jet.

        Repeat the process if necessary and rinse with water. Keep surface moist for the first few hours.

        Caution: Stone heads must be free from adhering mortar.

         

    • Application instructions
      • Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

        Protect wet mortar surfaces against frost, rain and drying out too quickly for at least 4 days.

        Slight deviations in colour between different batches are possible.

    • Working tools / cleaning
      • By brush
      • Mixer, rubber applicator, mortar raking disc, rubber scraper, foam rubber float, broom

      • Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Protect form moisture
      • Shelf-life 12 months
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

    • Usage
      • Approx 1.6 kg / l void
      • Approx. 1.6 kg/l joint space

      • Apply to a large enough trial area to determine the precise amount required.

    • General information
      • May contain traces of pyrite (iron sulphide).

        Low chromate content in accordance with Directive 2003/53/EC.

        The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

        The mixing water must be of drinking water quality.

        Always set up a trial area/trial areas first.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.