Article No. 136801
Stripping agent and graffiti remover
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Mechanically remove coarse soiling.
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
Apply the material using suitable equipment.
Action time depends on substrate, materials to be stripped, coating thicknesses and ambient climate.
After sufficient action time, remove the old coating mechanically using a suitable tool.
If needed, repeat the application.
Remove cleaning agent until no residues remain.
Make sure there is good ventilation.
Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.
Set up the necessary collection receptacles.
Extend the reaction time if necessary by covering with PE film.
Brush, surface brush (no artificial bristles), airless equipment
Clean tools with water immediately after use.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Approx. 0.3 - 0.5 l/m² per coat
Apply to a large enough trial area to determine the precise amount required.
The applicable regulations and legal requirements must be observed.
The relevant test certificates must be observed when planning and carrying out work.
Always set up a trial area/trial areas first.
Active ingredient residues and rinsing water that contains the active ingredients of the product must not be allowed to enter the surface water drainage system. Collect rinsing water and dispose of at a collection point or through the sewage system according to local regulations. For more information, see advisory leaflet DWA-M 370 on “Waste and sewage from the cleaning of and coating removal from facades”.
The object must be reported to the relevant authorities.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.