Article No. 4200264501
Solvent-based, decorative oil for wooden decking & garden furniture
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Wood building elements with limited or no dimensional stability: wood moisture content max. 18%
Wood which is rich in active substances should be weathered for a few weeks or cleaned with Wood Cleaner before being treated for the first time in order to prevent delays in the drying process.
Use an agent such as Wood Cleaner to remove any dirt, grease and old coatings that could form a film, making sure not to leave any residue.
Clean any greyed wood surfaces with Wood Revitalizer.
Remove algae with Green Growth Remover*.
Pre-treat wood in outdoor areas which requires protection against rot and blue stain with Wood Protection Primer.*
Temperature of material, surroundings and substrate: from min. +5 °C to max. +30 °C.
Apply by brush.
Treat all sides (of decking) on the first coat if possible.
Apply the product using a varnish brush, a surface brush or a (cotton) cloth in the direction of the grain.
Take up any excess material with a dry brush or cloth after a maximum of 30 minutes.
Apply a second coat once the first has dried (approx. 12 hours).
Seal opened containers well and use contents as soon as possible.
Check colour, adhesion and compatibility with the substrate by setting up a trial area.
Rainfall may cause water soluble substances to bleed from wood that is rich in such substances, e.g. oak, red cedar, afzelia, redwood, etc. This may lead to the discolouration of light-coloured masonry or render.
Clear does not protect from UV radiation (greying) and should therefore be used only on wood elements not directly exposed to weather (i.e. protected against direct sunlight, precipitation and wind). If a clear coating on a directly exposed surface outdoors is wished for, apply several coats and refresh at regular intervals.
Reapplications are required at least once a year in areas exposed to weathering.
Although the various colours are matched to a specific type of wood, they can easily be used on other types of wood as well, in which case the look of the colour will differ from the corresponding sample.
Risk of self-ignition (DGUV information brochure 209-046).
The product should not be applied at the same work stand as NC-based varnishes or stains. Collect any textiles soiled with the product (e.g. cleaning rags, work clothing) in fire-resistant waste containers and dispose of properly.
Dust-dry: approx. 4 hours Can be coated: approx. 12 hours
Practice values at +20 °C and 65% relative humidity.
Low temperatures, poor ventilation and high humidity delay drying.
Ready to use
Brush with natural bristles, flat brush, lint-free cotton cloth
Clean tools immediately after use with thinner and brush cleaner.
Ensure that any residue from cleaning is disposed of correctly.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 5 years.
60 - 80 ml/m² per coat, depending on the absorption capacity of the wood
On planed larch and softwoods with a high resin content, the coating may have reduced adhesion and resistance to weathering. This is especially the case on horizontal year rings, knots and areas of winter growth that are high in resin. Maintenance and renovation must be carried out more frequently on these surfaces. The only remedy for this is pre-weathering or very coarse sanding (P80). If these wood types are rough-sawn, considerably longer maintenance and renovation intervals are to be expected.
On terrace surfaces in the area of swimming pools, the increased exposure to chlorine, cleaning agents and intensive moisture can lead to reduced adhesion and weathering of the coating. Shorter maintenance and renovation intervals must be expected here.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.