Article No. 773201
Acrylic dispersion with special additives, free from solvents and plasticisers
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Joint sides must be clean, dry, free from grease and capable of bearing a load.
Use on the primer or intermediate coat.
Preliminary trials are generally advised in order to optimise the workflow and waiting times.
Temperature of the material, air and substrate: from min. +15 °C to max. +30 °C
Cut off tip at an angle according to the width of the joint and inject, filling the joint completely.
Apply the material with sufficient pressure to the sides of the joint, then smoothen with a moist spatula.
Avoid applying an excess of the fresh compound.
Use a suitable tool or finger cot to level off the filler.
Do not use in connection or expansion joints.
The product is not recommended for contact with solvent-based coatings.
Drying time (2 x 2 mm joint) Approx. 60 minutes (+23 °C/50% RH)
Low temperatures, poor ventilation and high humidity delay drying.
Sealant gun, Fensterfix scraper
Cleaning with water directly after use or with Aqua RK-898-Cleaning Concentrate for persistent contamination.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Approx. 5 ml/running metre for a 2 x 2 mm joint cross-section
Glued joints must be produced properly until glue is discharged over the entire surface area in accordance with the glue manufacturer's instructions.
When applying a subsequent coating on Induline AF-920, the layer must not be made too thick. The layer thicknesses specified in VFF Leaflet HO.03 must be observed.
On coarse-pored wood, we recommend sealing with AF-920 after applying the intermediate coating.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.