Article No. 266620
Water-based, translucent all-in-one coating system - fire behaviour tested to DIN EN 13501-1
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- For use on exterior wood
- Wood that has been impregnated with Adolit BSS1: application tested in outdoor areas not directly exposed to weathering
- Building elements with no or limited dimensional stability
- Only for industrial use as a system product with Adolit BSS 1
Properties
- Approved for system use with Adolit BSS1
- Protects the wood against moisture and UV radiation
- Does not flake
- Does not tear
- Film preserver protects against microbial damage
-
Preparation
-
Substrate requirements
The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.
Wood building elements with limited or no dimensional stability: wood moisture content max. 18%
-
Preparations
Use a brush to remove excess salt residues.
-
-
Application
-
Stir well, including during application or after a break in work.
Spray.
Flow cup gun: nozzle size: 2.0 - 2.5 mm; atomiser air pressure: 2.0 - 3.0 bar.
Airless spraying: nozzle size: 0.28-0.33 mm, material pressure: 80-100 bar (use yellow gun filter)
Air-mix spraying: nozzle size: 0.28-0.33 mm; material pressure: 70-90 bar, atomiser air pressure 1-2 bar.
After drying and, if necessary, intermediate sanding (P 280 - 320), apply a second coat.
Seal opened containers well and use contents as soon as possible.
-
-
Application instructions
-
Check colour, adhesion and compatibility with the substrate by setting up a trial area.
The treated components must be protected against rain and moisture (enclosed spaces, covered structures etc.) and must not be exposed to weathering.
-
Drying
Overcoating: after 1 - 2 hours
Practice values at +20 °C and 65% relative humidity.
Low temperatures, poor ventilation and high humidity delay drying.
-
Thinning
Ready to use
-
-
Working tools / cleaning
-
Spraying equipment, board coating machine
-
Clean tools with water or Aqua RK-898 Cleaning Concentrate immediately after use.
Ensure that any residue from cleaning is disposed of correctly.
-
-
Storage / shelf life
-
Store in well-sealed, original containers, out of the reach of children and in a dry, cool, well-ventilated room which is protected from direct sunlight and frost. No smoking is permitted in storage areas.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
-
-
Usage
-
93 ml/m² (100 g/m²) per coat in 2 coats (200 g/m²)
-
-
General information
-
Packing:
When packing multiple wood components together, use an intermediate layer of foamed PE film to separate them from one another. Do not pull the packing tape on the wood packets too tight.
Care and maintenance:
The coating system must always be kept in good condition. Any damage must be immediately reworked or repaired using this product.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-