Article No. 298405
High quality, low-emission interior wall paint with micro-silver as a film preserver for protection against fungal attack
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Surfaces at risk of mould, e.g. in living rooms, schools, nurseries, offices, hotels, restaurants, wellness facilities
- Finishing coat on mineral wall formers, renders, gypsum plasterboard, raw fibre and fibreglass wallpaper, adhering old coatings
- In areas for people sensitive to mould (children, people with allergies)
Properties
- Water vapour diffusion capable
- Hard-wearing and resistant to scrubbing (wet abrasion class 2 as per DIN EN 13300)
- Good hiding power (class 2 as per DIN EN 13300)
- Gloss level: matt
- Free from solvents and plasticizers
-
Preparation
-
Substrate requirements
Dry, clean, free of dust and cracks (except hairline cracks) and capable of supporting a load.
Structural deficiencies such as heat bridges must be eliminated.
Condensation must be avoided.
-
Preparations
Completely remove any superficial mould infestation using Remmers Mould Stop*.
-
-
Application
-
Application requirements
Temperature of the material, air and substrate: from min. +8 °C to max. +25 °C
-
Stir well.
Coat the surface using a suitable tool.
Apply the material in 2 coats, depending on the condition of the substrate.
Wait at least 8 hours between coats.
-
Application instructions
-
Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.
The first coat can be diluted with up to 5% water.
-
-
Working tools / cleaning
-
Brush, flat brush, lamb's wool roller, ceiling brush
-
Clean tools with water while the material is still fresh.
Clean splashed material with water while the material is still fresh.
-
Storage / shelf life
-
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
-
Usage
-
Approx. 0.15 l/m² per coat (depending on the substrate properties).
-
Apply to a large enough trial area to determine the precise amount required.
-
General information
-
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Always set up a trial area/trial areas first.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-