Article No. 026115
Surface filler and fine plaster in the Power Protect [eco] system
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Clean, dust-free and capable of supporting a load.
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
Using a toothed trowel, apply the material in a coating thickness of 3 mm.
Ensure that fabric sheets overlap by at least 10 cm.
Smooth the surface using a suitable tool.
Carry out subsequent surface treatment after material has stiffened.
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.
Depending on the ambient conditions, in heated rooms or draughty areas, use a film or similar apparatus to prevent the material from setting too quickly.
Mixer, smoothing trowel, wood or felt wheel, trowel, sponge float
Clean tools with water while the material is still fresh.
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
Approx. 1.3 kg/m²/mm layer thickness, full-surface approx. 6.0 kg/m²
Do not work on substrates where moisture is penetrating from the rear.
The colour that is obtained after drying and hardening depends on the ambient conditions and the processing method. For instance, a freshly smoothed surface will be lighter than one that is smoothed later or roughened. Different grain sizes of the same product may lead to slight differences in colour. Substrates soaked from the back may cause discolouration.
May contain traces of pyrite (iron sulphide).
Do not use on gypsum-based substrates.
The mixing water must be of drinking water quality.
Low chromate content in accordance with Directive 2003/53/EC.
Always set up a trial area/trial areas first.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.