• 0000026501_Power_Protect-R_15
    eco
    Product

    Article No. 0265

    Power Protect R 15 [eco]

    Reveal board in the Power Protect [eco] system

    Product specifications

    On delivery

    Water vapour diffusion approx. 5
    Thermal conductivity λ 0.06 W/(m∙k)

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors
    • Restricted space conditions, e.g. reveals
    • Floor/connecting areas

    Properties

    • Environmentally friendly and mould-inhibiting
    • Protects health and the environment
    • Water vapour permeable
    • Capillary-active
    • Thermally insulating, lambda 0.06 W/(m∙K)
    • Low construction height
    • Easy to work
    • Preparation
      • Substrate requirements

        The substrate must be clean and capable of bearing a load.

        The substrate must be level.

      • Preparations

        Level off and even out highly uneven substrates – use SP Levell to seal joints and even out surfaces.

    • Application
      • Application temperature: min. 5 °C max. 30 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

      • Use the material to level out any unevenness of < 8 mm in the substrate.

        Apply the material vertically to the substrate with a middle-bed trowel (toothed).

        Press on the board, beginning at the bottom.

        A full-surface bonding is to be achieved.

    • Application instructions
      • Mark the desired dimensions on the board.

        Cut with a cutter knife or keyhole saw.

        Rework the cut edges with a rasp or file if necessary.

        Place the boards, starting at the bottom.

        Avoid cross joints.

        Make sure that the board surface is aligned correctly (the label "front side" must be visible after application).

        Then, use PP Fill to smooth off and create fine, closed surfaces that are ready for painting.

    • Storage / shelf life
      • Store frost-free
      • Unlimited if stored in frost-free conditions.

    • Usage
      • 4.5 panels/m²
      • Approx. 4.5 boards/m²

    • General information
      • Typical inherent odour after installation, while the finishing plaster is drying.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • The product must be disposed of in accordance with the official regulations.