Article No. 022525
Adhesive mortar in the iQ Therm system
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Clean, dust-free and capable of supporting a load.
Pre-wet the substrate so that it is slightly moist.
Pretreat highly absorbent substrates with Primer Hydro F (Art. 2842).
Level off and even out highly uneven substrates – use SP Levell to seal joints and even out surfaces.
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
Use the material to level out any unevenness of < 8 mm in the substrate.
Using a notched trowel, apply the material evenly using a buttering-floating method.
Press on the board, beginning at the bottom.
A full-surface bonding is to be achieved.
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Wait a minimum of 24 hours between bonding and filling panels.
Mixer, smoothing trowel, trowel, notched trowel
Clean tools with water while the material is still fresh.
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
Buttering-floating method: 7.0 - 8.0 kg/m²
Do not use on gypsum-based substrates.
The mixing water must be of drinking water quality.
May contain traces of pyrite (iron sulphide).
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Low chromate content in accordance with Directive 2003/53/EC.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.