• iQ_Fill_Q4

    Article No. 023320

    iQ Fill Q4

    Fine filler

    Colour: iQ-Fill Q4 | 0233
    Size / Quantity

    Brochures and Catalogues

    product.brochures.loading

    Product specifications

    On delivery

    Maximum grain size ≤ 0.1 mm
    Layer thickness Seamless up to max. 2 mm
    Bulk density Approx. 1.1 kg/dm³
    Water requirement Approx. 7.0-8.0 l/20 kg
    Water absorption coefficient w24 > 1 kg/m²
    Water vapour permeability µ < 14
    Compressive strength class CS II (1.5 - 5.0 N/mm²)

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors
    • Interior use
    • Creating fine, closed plaster surfaces that are ready for painting
    • Surface quality grades Q2-Q4

    Properties

    • Seamless feathering
    • Good sanding properties
    • Good adhesive power
    • Insusceptible to moisture
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

      • Preparations

        Pre-wet the substrate so that it is slightly moist.

    • Application
      • Toothed trowel / toothed blade
      • Application temperature: min. 5 °C max. 30 °C
      • Apply product in the desired coating thickness.

        Smooth the surface using a suitable tool.

        Can be sanded once set.

         

    • Application instructions
      • Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

        Protect the material from drying too quickly.

        Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.

    • Working tools / cleaning
      • Toothed trowel / toothed blade
      • Mixer, trowel, smoothing trowel, sponge float, smoothing board

      • Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Protect form moisture
      • Shelf-life 12 months
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

    • Usage
      • Approx. 2.2 kg/m² at a coating thickness of 2 mm

    • General information
      • Do not work on substrates where moisture is penetrating from the rear.

        The colour that is obtained after drying and hardening depends on the ambient conditions and the processing method. For instance, a freshly smoothed surface will be lighter than one that is smoothed later or roughened. Different grain sizes of the same product may lead to slight differences in colour. Substrates soaked from the back may cause discolouration.

        May contain traces of pyrite (iron sulphide).

        Do not use on gypsum-based substrates.

        The mixing water must be of drinking water quality.

        Low chromate content in accordance with Directive 2003/53/EC.

        Always set up a trial area/trial areas first.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Possible system products