Article No. 024305
iQ-Therm 80
Downloads & documents
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Mould control and prevention in existing buildings
- Implementation of the hygienic minimum heat insulation level in existing buildings
- Improving the room climate by increasing the wall surface temperature
Properties
- EG_SCH_29
- Water vapour permeable
- Capillary-active
- EG_SCH_27
- Low construction height
- Easy to work
- EG_SCH_28
-
Preparation
-
Substrate requirements
The substrate must be clean and capable of bearing a load.
The substrate must be level.
-
Preparations
Level off and even out highly uneven substrates – use SP Levell to seal joints and even out surfaces.
-
-
Application
-
Pre-wet the substrate.
VA1_iQ_9
VA1_iQ_10
Position and press on the boards from the bottom up.
Align using a floating rule.
-
-
Application instructions
-
Mark the desired dimensions on the board.
Cut using a keyhole saw or hand-held circular saw.
Rework the cut edges with a rasp or file if necessary.
VA2_SCH_10
Avoid cross joints.
Make sure that full-surface bonding is achieved.
-
-
Storage / shelf life
-
Dry and frost-free.
-
-
General information
-
Deviations from applicable regulations must be agreed separately.
-
-
Disposal instructions
-
The product must be disposed of in accordance with the official regulations.
-
Ratings
