Article No. 024208

    iQ-Therm 50

    Variant
    Variant
    0242 | iQ-Therm 50
    Packaging unit

    Product specifications

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • Mould control and prevention in existing buildings
    • Implementation of the hygienic minimum heat insulation level in existing buildings
    • Improving the room climate by increasing the wall surface temperature

    Properties

    • Excellent thermal insulation
    • Water vapour permeable
    • Capillary-active
    • Thermal conductivity (nominal value) approx. 0.031 W/(m•K)
    • Low construction height
    • Easy to apply
    • Thermal insulation material according to DIN 4108-10
    • Preparation
      • Substrate requirements

        The substrate must be clean and capable of bearing a load.

        The substrate must be level.

      • Preparations

        Level off and even out highly uneven substrates – use SP Levell to seal joints and even out surfaces.

    • Application
      • Pre-wet the substrate.

        Apply iQ Fix to the substrate as a scratch coat.

        Using a notched scraper, apply iQ Fix wet-on-wet to the rear face of the panel and the substrate.

        Position and press on the boards from the bottom up.

        Align using a floating rule.

    • Application instructions
      • Mark the desired dimensions on the board.

        Cut using a keyhole saw or hand-held circular saw.

        Rework the cut edges with a rasp or file if necessary.

        Make sure that the panels are correctly aligned (the side marked "plaster side" must be visible after application).

        Avoid cross joints.

    • Storage / shelf life
      • Dry and frost-free.

    • General information
      • Deviations from applicable regulations must be agreed separately.

    • Disposal instructions
      • The product must be disposed of in accordance with the official regulations.

    Different variants