Article No. 023215

    iQ-Fill

    Button Energie Effizienz
    Variant
    0232 | iQ-Fill
    Packaging unit

    Product specifications

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on walls indoors and ceilings
    • Indoor areas
    • Creating fine, closed plaster surfaces that are ready for painting
    • Surface quality grades Q1-Q3

    Properties

    • Enables water vapour diffusion
    • Highly capillary active
    • Good adhesive power
    • Insusceptible to moisture
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

      • Preparations

        Pre-wet the substrate so that it is slightly moist.

    • Application
      • Toothed trowel / toothed blade
      • Application temperature: min. 5 °C max. 30 °C
      • Contact layer

        Using a suitable tool, apply the product as a contact layer.

         

        Reinforcing layer

        Using a toothed trowel, apply the material in a coating thickness of 3 mm.

        VA1_M_703

        Ensure that fabric sheets overlap by at least 10 cm.

         

        Surface decoration

        VA1_M_704

        Smooth the surface using a suitable tool.

        Carry out subsequent surface treatment after material has stiffened.

         

    • Application instructions
      • Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

        Depending on the ambient conditions, in heated rooms or draughty areas, use a film or similar apparatus to prevent the material from setting too quickly.

        Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.

    • Working tools / cleaning
      • Toothed trowel / toothed blade
      • Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Protect form moisture
      • Shelf-life 12 months
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

    • General information
      • Do not work on substrates where moisture is penetrating from the rear.

        The colour that is obtained after drying and hardening depends on the ambient conditions and the processing method. For instance, a freshly smoothed surface will be lighter than one that is smoothed later or roughened. Different grain sizes of the same product may lead to slight differences in colour. Substrates soaked from the back may cause discolouration.

        May contain traces of pyrite (iron sulphide).

        Do not use on gypsum-based substrates.

        The mixing water must be of drinking water quality.

        Low chromate content in accordance with Directive 2003/53/EC.

        Always set up a trial area/trial areas first.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.