Article No. 650005
High-quality, pure acrylate facade paint
* These values refer to a two-layer coating with a dry film thickness of 140 μm.
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Dry, clean, free of dust and cracks (except hairline cracks) and capable of supporting a load.
Free of aggressive salts.
Remove any old coatings not capable of supporting a load, making sure not to leave any residue.
Use Impregnation Primer to prime mineral substrates capable of supporting a load.
Use Primer SV or Hydro Deep Primer to prime any sanding, firmly adhering substrates.
Temperature of the material, air and substrate: from min. +5 °C to max. +25 °C
Coat the surface using a suitable tool.
Apply the material in 2 or 3 coats, depending on the condition of the substrate.
Wait at least 8 hours between coats.
Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.
When coating continuous surfaces, only use materials with the same batch number.
Intensive colours, such as yellow, red, etc. may have a lower hiding power due to their pigments. Apply an additional coat if required.
Protect freshly treated surfaces from driving rain, wind, sunlight and condensation.
Brush, surface brush, lambskin roller, airless spraying equipment.
Clean tools, equipment and any splashed material immediately with water while still fresh.
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Approx. 200 ml/m² per coat depending on the condition of the substrate
The application rate depends on the absorbency of the surface
Apply to a large enough trial area to determine the precise amount required.
For information on the surface protection systems OS 2 and OS 4, see the relevant test report
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Always set up a trial area/trial areas first.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.