• PU AW

    Article No. 763060

    PU AW

    Elastic joint sealing compound based on PUR synthetic resins

    Colour: black | 7630
    Size / Quantity

    Note: This container size is being phased out and is only available to a limited extent.

    Product specifications

    Density (20°C) 1.18 g/ml
    Skin formation Approx. 14 hours (+23 °C/50% RH)
    Curing rate Approx. 0.2 mm/day (+23 °C/50% RH)

    Once fully cured

    E-modulus
    100% (DIN EN ISO 8339)
    0.8 N/mm²
    Shore A (DIN EN ISO 868) 32
    Elongation at break (DIN EN ISO 8339) > 130%

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors and outdoors
    • Waterproofing in sewage and water treatment plant areas
    • Sewage pits, joints in contact with the ground
    • Wall areas

    Properties

    • Resistant to water, seawater, waste water, sewage, weak acids and alkalis
    • Resistant to a wide range of solvents, short-term resistance against petrol
    • High gas diffusion resistance
    • Test report available
    • Preparation
      • Substrate requirements

        The sides of the joints must be dry to slightly damp, clean, free from grease and capable of bearing a load, and metals must be sound.

         

        Adhesive primer

        Joints subjected to heavy loads - Primer PUR

         

        Underwater areas:

        Dry joint edges - Underwater Primer

        Slightly damp joining edges - Epoxy MT 100

    • Application
      • Application temperature: min. 5 °C max. 40 °C
      • Gun for sealing compounds
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +40 °C

      • Cut off tip at an angle to match the joint width.

        Apply the material to the joint edges with sufficient pressure.

        Pull off using a smoothing agent and a suitable tool.

    • Application instructions
      • Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

        Joint dimensions depend on the loading stresses, the building material properties, and the permissible total deformation of the sealant.

        The applicable regulations and legal requirements must be observed.

        Can be removed while wet with V 101, can only be removed via mechanical means once set.

    • Working tools / cleaning
      • Gun for sealing compounds
      • Manual or compressed air gun, smoothing tool, adhesive tape

        Clean with V 101 while wet.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 9 months
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 9 months.

    • Usage
      • Total application rate approx. 100 ml / cm² x m
      • 100 ml/running metre for a joint cross-section of 1 cm²

      • Apply to a large enough trial area to determine the precise amount required.

    • General information
      • Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

        Always set up a trial area/trial areas first.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.