Article No. 108225
Mineral-based bonding layer
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Clean, dust-free and capable of supporting a load.
Pre-wet the substrate so that it is slightly moist.
Expose the grains close to the surface
The substrate must have an average pull-off strength of at least 1.5 N/mm²
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
Apply the material to slightly damp surfaces.
Follow-up work must be carried out wet ond wet.
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Mixer, trowel, wide grout brush, brush, grout broom
Clean tools with water while the material is still fresh.
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
Approx. 1.1 kg/m² per coat
The mixing water must be of drinking water quality.
The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.