WP Top

The substrate must be level, clean, dust-free and stable, and free of oil, grease and release agents.

Remove plasters, paints and coatings to at least 80 cm above the damaged area or as indicated by examination and scrape out damaged joints to a depth of approx. 2 cm.

Primer

Apply an even layer of Kiesol (1:1 with water).

Pre-wet highly absorbant substrates with water.

If necessary, pre-treat salt-contaminated substrates with Salt IH and/or Sulfatex LQ (without Kiesol).

Bonding layer

Mix WP Top [basic] to a slurry consistency and apply as a bonding layer to the slightly damp primer.

Alternatively: apply a bonding layer of WP Sulfatex or SP Prep as a preparatory mortar to the surface once it has been levelled.

Levelling

Level out unevenness, depressions > 5 mm and joints with WP Top [basic].

Apply the plaster to the fresh bonding layer, or after 2-4 days if SP Prep is used as a bonding layer.

Apply the product using suitable tools or machine equipment in one or two coats with a layer thickness of min. 10 mm to max. 30 mm.

When applying two coats, roughen the first coat with a render comb and apply the second coat after sufficient drying.

After application, smooth the surface with a plasterer's float.

Finish the surface once set.

Prepare the surface for subsequent coats after sufficient drying using a grated scraper. Apply subsequent coats after 2-7 days.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

Protect wet mortar surfaces against frost, rain and drying out too quickly for at least 4 days.

Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.

Please contact Remmers Technical Service (phone +49 5432 83900) before applying with machine processing.

Mixing tool, trowel, smoothing trowel, plastic float, grated scraper, toothed trowel, plasterer's float

Clean tools with water while the material is still fresh.

If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

Approx. 1.6 kg/m²/mm layer thickness or approx. 1.6 kg/dm³

Apply to a large enough trial area to determine the precise amount required.

May contain traces of pyrite (iron sulphide).

Do not use on gypsum-based substrates.

The mixing water must be of drinking water quality.

Low chromate content in accordance with Directive 2003/53/EC.

Always set up a trial area/trial areas first.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.